How To Set Preferences - Calculated Industries 44080 Construction Master Pro Desktop v3.0 User Manual

(Cont'd)
PREFERENCE
8) Exponent Off or On
9) Meter Linear Display
10) Decimal Degree
Display

How to Set Preferences

The following sections detail Preference Setting options for the
Construction Master Pro calculators.
Enter the Preference Mode by pressing Ç ß (Prefs) . Access
each category by pressing the ß key until you reach the desired
setting. Within each category, press the + or – keys to toggle
between individual selections. Press o to exit and set your
Preference.
Note: Press + to advance and press – to back up. Pressing the ß key continuously
in this mode will cycle through all of the Preference Settings.
You may change these settings at any time by repeating the above,
and setting in a new preference. Or, you may review settings by
pressing ® ß.
To clear preferences, press Ç x.
For example, if you wish to display all your dimensional area answers
in square meters, press Ç ß ß (Area Std) , then the + key
until "AREA 0.
o or any key, and all your future area answers will be displayed
in square meters.
(See the following pages for Preference Settings per model)
OPTIONS
– *Off (Exponential Mode is Off; turns
on Auto-ranging; i.e., if display can't
show seven digits, will display in next
largest unit).
– On (Exponential Mode is On)
– *0.000 (linear meter answers are
always displayed to third decimal place)
– FLOAT (linear meter answers are dis-
played to the maximum number of deci-
mal places—e.g., 1.234 M + 2.56
M=3.794 M)
– *0.00°
– FLOAT
" is displayed. Simply exit this mode by pressing
SQ M
U ' G — 91
SER S UIDE