Appendix A - Default Settings - Calculated Industries 4065 User Manual

APPENDIX A — DEFAULT SETTINGS
After a Clear All (Ç x), your calculator will return to the following
settings:
STORED VALUES
Desired Riser Height
Desired Tread Width
Floor Height
On-center Spacing
Weight per Volume
Block Area (except Trig model)
Block Length (except Trig model)
Footing Area (except Trig model)
Spring (Crown) Angle
If you replace your batteries or perform a Full Reset* (press O, hold
down x, and press o), your calculator will return to the following
settings (in addition to those listed above):
PREFERENCE SETTINGS
Fractional Resolution
Area Display
Volume Display
Stairway Headroom
Rake Wall
Arched Wall
Jack Rafters
Irregular Jack Spacing
Exponent
Meter Linear Display
Decimal Degree Display
Fractional Mode
*Depressing the Reset button located above the p key (below the Ç key on the
Desktop model) will also perform a Full Reset.
82 — C
ONSTRUCTION
M ® P / T
ASTER RO
DEFAULT VALUE
7-1/2
INCH
10
INCH
10
INCH
16
INCH
1.5
on er
T P CU YD
128.
SQ INCH
16
INCH
264.
SQ INCH
45.00°
DEFAULT VALUE
1/16
Standard
Standard
6 Feet 8 Inch
Descending
Outside
Descending
OC-OC
Off
0.000
0.00°
Standard
/ D
RIG ESKTOP