Recall ® Key; Dimensional Measurement Unit Keys - Calculated Industries 4065 User Manual

Recall ® Key
The ® key is used to recall or review stored values (e.g., ® p
to recall a previously entered pitch value). It is also used in reviewing
stored settings, or in Paperless Tape and Memory operation (see
below).
® =
® ®
® µ
® 1 – 3

Dimensional Measurement Unit Keys

The following keys are used for entering units of measure, with ease
and accuracy:
y
f
i
/
Paperless Tape (Tape) — Accesses the paperless
tape mode (see "Paperless Tape" page 27), which
keeps track of your past 20 entries. Useful for
checking strings of numbers.
Clear M+ — Displays and clears M+.
Recall M+ — Displays value stored in M+.
Recall (M1) through (M3) — Recalls the value
stored in M1, M2, or M3.
Yards — Enters or converts to Yards .
Feet — Enters or converts to Feet . Also used with
the i and / keys for entering Feet-Inch values
(e.g., 6 f 9 i 1 / 2).
Note: Repeated presses of f after Ç toggle between Feet-
Inches and Decimal Feet (e.g., 6 f 9 i 1 / 2 Ç f =
6.791667 Feet; press f again to return to Feet-Inch-Fractions).
Inches — Enters or converts to Inches . Also used
with the / key for entering fractional Inch values
(e.g., 9 i 1 / 2).
Note: Repeated presses of i after Ç toggle between
Fractional and Decimal Inches (e.g., 9 i 1 / 2 Ç i =
9.5 Inch; press i again to return to Fractional Inches).
Fraction Bar — Used to enter fractions . Fractions
may be entered as proper (1/2, 1/8, 1/16) or improper
(3/2, 9/8). If the denominator (bottom) is not entered,
the calculator's fractional resolution setting is auto-
matically used (e.g., entering 1 5 / = or + will
display 15/16, based on the default fractional resolu-
tion setting of 16ths.
U ' G — 3
SER S UIDE