Appendix B - Preference Settings - Calculated Industries 4065 User Manual

APPENDIX B — PREFERENCE SETTINGS
The Construction Master Pro calculators have Preference Settings
that allow you to customize or set desired dimensional formats and
calculations. The options vary per model.
If you replace your batteries or perform a Full Reset* (press O, hold
down x, and press o), your calculator will return to the following
settings (in addition to those listed on the previous page):
*Depressing the Reset button located above the p key (below the Ç key on the
Desktop model) will also perform a Full Reset.
PREFERENCE
1) Fractional Resolution
2) Area Display Format
Note: To check the current Fractional Resolution, press ® / . Either "Std" (standard
fractional resolution) or "Cnst" (constant) will be displayed, along with the fractional
resolution).
OPTIONS
– *1/16 (displays fractional values to the
nearest 16th of an Inch)
– 1/32
– 1/64
– 1/2
– 1/4
– 1/8
– *Standard (if units entered are the
same—e.g., Feet x Feet—the answer
will remain in this format (Square Feet),
but if units entered are different — e.g.,
Inches x Feet—area answer will be dis-
played in Square Feet)
– Square Feet (area answers always
displayed in Square Feet, regardless of
unit entry — e.g., Inches x Inches =
Square Feet)
– Square Yards (area answers always
displayed in Square Yards — e.g.,
Feet x Feet = Square Yards)
– Square Meters (area answers always
displayed in Square Meters — e.g.,
Feet x Feet = Square Meters)
(Cont'd)
U ' G — 83
SER S UIDE