Appendix G - Preference Settings - Calculated Industries Sheet Metal/HVAC Pro Calc User Manual

APPENDIX G — PREFERENCE SETTINGS
Your calculator has Preference Settings that allow you to customize
or set desired dimensional formats and calculations. See the list of
Settings below and instructions how to set them on the following
page.
If you replace your batteries or perform a Full Reset* (press O, hold
down x, and press o), your calculator will return to the following
settings (in addition to those listed on the previous page):
PREFERENCE
1) Fractional Resolution
2) Area Display Format
OPTIONS
— *1/16 (displays fractional values to
the nearest 16th of an Inch)
— 1/32
— 1/64
— 1/2
— 1/4
— 1/8
— *Standard (if units entered are the
same — e.g., Feet x Feet — the answer
will remain in this format (Square Feet),
but if units entered are different — e.g.,
Inches x Feet — area answer will be
displayed in Square Feet)
— Square Feet (area answers always
displayed in Square Feet, regardless of
unit entry — e.g., Inches x Inches =
Square Feet)
— Square Meters (area answers
always displayed in Square meters —
e.g., Feet x Feet = Square Meters)
(Cont'd)
U ' G — 107
SER S UIDE