Recall ® Key; Dimensional Measurement Unit Keys - Calculated Industries 44080 Construction Master Pro Desktop v3.0 User Manual

Recall ® Key
The ® key is used to recall or review stored values (e.g., ® p
to recall a previously entered pitch value). It is also used in reviewing
stored settings, or in Paperless Tape and Memory operation (see
below).
® =
® ®
® µ
® 1 – 3

Dimensional Measurement Unit Keys

The following keys are used for entering units of measure, with ease
and accuracy:
y
f
i
/
10 — C
ONSTRUCTION
(Paperless) Tape — Accesses the paperless tape
mode (see "Paperless Tape" page 35), which keeps
track of your past 20 entries. Useful for checking
strings of numbers.
Clear M+ — Displays and clears M+.
Recall M+ — Displays value stored in M+.
Recall (M1) through (M3) — Recalls the value
stored in M1, M2, or M3.
Yards — Enters or converts to yards .
Enters or converts to feet . Also used with the i
and / keys for entering feet-inch values (e.g., 6
f 9 i 1 / 2).
Note: Repeated presses of f after Ç toggle between feet-
inches and decimal feet (e.g., 6 f 9 i 1 / 2 Ç f
= 6.791667 feet; press f again to return to feet-inch-fractions).
Enters or converts to inches . Also used with the /
key for entering fractional inch values (e.g., 9 i
1 / 2).
Note: Repeated presses of i after Ç toggle between frac-
tional and decimal inches (e.g., 9 i 1 / 2 Ç i = 9.5
inch; press i again to return to inch-fractions).
Fraction Bar — Used to enter fractions . Fractions
may be entered as proper (1/2, 1/8, 1/16) or improper
(3/2, 9/8). If the denominator (bottom) is not entered,
the calculator's fractional resolution setting is auto-
matically used (e.g., entering 1 5 / = or + will
display 15/16, based on the default fractional resolu-
tion setting of 16ths.
M ® P
ASTER
/ T / D
RO RIG ESKTOP