Chapter 34: Replacing The Display Assembly; Procedure; Post-Requisites - Dell 3000 Series Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
•

Procedure

•

Post-requisites

Procedure
1. Place the display assembly on the palm-rest assembly.
2. Close the display hinges and align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
3. Replace the screws that secure the display hinges to the palm-rest assembly.
4. Route the display cable through its routing guides on the palm-rest assembly.
5. Route the antenna cables through its routing guides on the palm-rest assembly.
6. Close the display and turn the computer over.
Post-requisites
1. Replace the system board.
2. Replace the heat sink.
3. Replace the I/O board.
4. Replace the wireless card.
5. Replace the memory module.
6. Follow the procedure from step 4 to step 6 in
7. Follow the procedure from step 3 to step 7 in
8. Follow the procedures from step 4 to step 5 in
9. Replace the keyboard.
10. Replace the battery.
62 Replacing the display assembly
Replacing the display assembly
computer. After working inside your computer, follow the instructions in
"Replacing the hard
"Replacing the base
"Replacing the optical
drive".
cover".
drive".
34
After