Chapter 30: Replacing The Touch Pad; Procedure; Post-Requisites - Dell 3000 Series Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
•

Procedure

•

Post-requisites

Procedure
1. Place the touch pad on the palm-rest assembly.
2. Slide the tabs on the touch-pad bracket into the slots on the palm-rest assembly.
3. Slide the touch-pad cable into the connector on the touch pad and close the latch to secure the cable.
4. Align the screw holes on the touch-pad bracket with the screw holes on the palm-rest assembly.
5. Replace the screws that secure the touch-pad bracket to the palm-rest assembly.
6. Adhere the tape over the touch-pad bracket.
Post-requisites
1. Replace the heat sink.
2. Replace the I/O board.
3. Replace the wireless card.
4. Replace the memory module.
5. Follow the procedure from step 4 to step 6 in
6. Follow the procedure from step 3 to step 7 in
7. Follow the procedures from step 4 to step 5 in
8. Replace the keyboard.
9. Replace the battery.
Replacing the touch pad
computer. After working inside your computer, follow the instructions in
"Replacing the hard drive".
"Replacing the base cover".
"Replacing the optical drive".
Replacing the touch pad
30
After
55