Table of Contents
Advertisement
Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Align the screw holes on the display assembly with the screw holes on the
computer base.
2
Replace the two screws (M2.5x5) that secure the display assembly to the
computer base.
3
Close the display and turn the computer over.
4
Replace the two screws (M2.5x5) that secure the display assembly to the
computer base.
5
Replace the two screws (M2x3) that secure the display assembly to the
computer base.
6
Adhere the display cable and the camera cable to the computer base.
7
Route the antenna cables through the routing guides on the computer base.
8
Connect the display cable and camera cable to the system board.
9
Align the screw hole on the display-cable bracket with the screw hole on the
system board.
10 Replace the screw (M2x3) that secures the display cable bracket to the system
board.
Post-requisites
1
Follow the procedure from step 3 to step 9 in
keyboard
assembly".
2
Replace the
rear
3
Replace the battery.
86
computer. After working inside your computer, follow
After working inside your
cover.
computer. For more safety best
www.dell.com/
"Replacing the palm rest and
Before
Advertisement
Table of Contents
