Chapter 33: Removing The Display Assembly; Prerequisites; Procedure - Dell 3000 Series Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
•

Prerequisites

•

Procedure

Prerequisites
NOTE: These instructions are applicable only for laptops with a non-touch screen display.
1. Remove the battery.
2. Follow the procedure from step 1 to step 3 in
3. Remove the keyboard.
4. Follow the procedure from step 1 to step 5 in
5. Follow the procedure from step 1 to step 3 in
6. Remove the memory module.
7. Remove the wireless card.
8. Remove the I/O board.
9. Remove the heat sink.
10. Remove the system board.
Procedure
1. Remove the screws that secure the display hinges to the palm-rest assembly and open the hinges to an angle of 90 degrees.
2. Note the antenna cable routing and remove the cable from its routing guides on the palm-rest assembly.
3. Note the display cable routing and remove the cable from its routing guides on the palm-rest assembly.
Removing the display assembly
computer. After working inside your computer, follow the instructions in
"Removing the optical
"Removing the base
"Removing the hard
drive".
cover".
drive".
Removing the display assembly
33
After
59