Jump Starting - Ransomes G-Plex II Safety And Operation Manual

GB
• UNTRAINED/UNAUTHORIZED persons
should NEVER attempt to service or
recharge the battery in this unit.
• Battery electrolyte is an acidic solution
and should be handled with care. If
electrolyte is splashed on any part of
the body, immediately flush the
exposed area with liberal amounts of
water and obtain medical aid
immediately.
NOTICE
• Keep top of battery clean and free of
corrosion by washing with a solution of
baking soda and water OR ammonia and
water. Rinse with clean water. Batteries
with heavy corrosion should be removed
and cleaned with solution.
• Battery cables should be disconnected
before using a "Fast Charger."

JUMP STARTING

•
DO NOT allow flames or sparks near a
battery when connecting for jump starting
or charging.
•
Hydrogen gas is produced during the
charging process and can be explosive.
Provide adequate ventilation to prevent
possible explosion.
Both booster battery and discharged battery should
be treated carefully when using jumper cables.
Follow these steps exactly, take care not to cause
sparks.
1. Set the parking brake and turn off any
electrical loads.
2. Attach one end of one jumper cable to the
positive terminal of the booster battery and
the other end to the positive terminal of
the discharged battery. DO NOT permit
units to touch each other.
3. Attach one end of remaining cable to the
negative terminal of the booster battery
and the other end to a good ground on the
unit or engine, away from the discharged
battery. DO NOT lean over the battery
when making this connection.
Reverse this sequence exactly when removing the
jumper cables.
NOTICE
• Booster batteries used for starting must be
connected with proper polarity.
GB-18
WARNING
WARNING
WARNING
RANSOMES G PLEX II Series :WD
SAFETY AND OPERATORS MANUAL
TYRE PRESSURE
•
Caution must be used when inflating a low
tyre to recommended pressure. Check
pressure with a low pressure tire gauge
before connecting an air hose to a partly
inflated yire.
•
Due to the low air volume requirements of
a small tire, over inflation may be reached
in a matter of a few seconds, which could
cause the tire to explode.
COLD INFLATION PRESSURE
All Tires 9 PSI (60.3 kPa)
NOTICE
• Improper inflation will reduce tyre life
considerably
CUTTING HEAD MAINTENANCE
CLEANING
The cutting heads should be washed after each days
use and dried as well as possible to prevent rust.
All cutting surfaces (reel and bedknife) should be
given a light coating of oil or other anti–rust
compound.
LUBRICATION
The lubrication fittings at each end of both the front
and rear rollers, as well as the reel bearings at each
end should be lubricated periodically (approximately
once each week). Use only enough lubricant to keep
the bearings from drying out. Too much lubricant
may drop from mower onto turf, causing damage to
the grass.
2
1
Figure 30
1. Rollers (fittings at both ends)
2. Reel Bearings (both ends)
3. Rotary Brush Accy. (both ends)
CAUTION
CAUTION
3
SHOWN WITH
BRUSH ACCESSORY
MOUNTED
1