Feeding The Label - Peel-Off Mode - Brady BP-IP300 Operation/Configuration Manual

Loading the Ribbon and Material
Feeding the Label — Peel-Off Mode
.
2
1
1. Pressure roller (engaged)
2. Pressure roller (disengaged)
3. Pressure roller
1. Load the labels on the material supply holder. Refer to Loading the
Material on page 25.
2. Position the label strip between the label guides (Figure 21, 2) and turn
the adjustment wheel (Figure 21, 1) to snug the guides just up against
the label strip. Be careful not to tighten the guides against the label strip
enough to crimp the label strip.
3. Press on the metal pins at each end of the pressure roller (Figure 23, 3)
and slide the roller from the disengaged position (Figure 23, 2) into the
engaged position (Figure 23, 1).
4. Remove the labels (Figure 23, 5) from about the first 6 inches
(152.4 mm) of the label backing (Figure 23, 4).
28
3
Figure 23, Peel-Off Mode
4. Label backing
5. Label
4
4
5