Usb Connection; Rs-232 Connection; Ethernet Connection; Usb Printer Driver - Brady BP-IP300 Operation/Configuration Manual

Installation

USB Connection

1. Ensure that the Brady IP Printer is turned off.
2. Connect the printer to the computer using the supplied USB cable. The
USB cable connects to the printer at the USB port (Figure 2, 2) and to a
USB port on the computer.

RS-232 Connection

1. Ensure that the Brady IP Printer is turned off.
2. Connect the printer to the computer using an RS-232 cable (not
provided). The RS-232 cable connects to the printer at the port
(Figure 2, 1) and to the computer.
3. Secure the cable with the connection screws.
4. Configure the printer RS-232 interface to match the connected computer.
Refer to Interfaces on page 52.

Ethernet Connection

1. Ensure that the Brady IP Printer is turned off.
2. Connect the printer to the computer using an Ethernet cable (not
provided). The Ethernet cable connects to the printer at the Ethernet port
(Figure 2, 3) and to an Ethernet port on the computer or Local Area
Network (LAN).

USB Printer Driver

Do not install drivers if using Bradysoft. Bradysoft
uses its own drivers. Follow instructions included
with Bradysoft to set up your IP printer using
USB, serial or Ethernet connections.

Printer Wizard

1. Insert the product CD in the CD drive on your computer. Turn the printer
power on. Connect the USB cables (refer to USB Connection on page 8).
The Found New Hardware dialog box appears.
8
NOTICE