Electrical Supply; Gpo (General Purpose Outlet); Direct Wired Installations - Rinnai RDV600ER Installation Manual

ELECTRICAL SUPPLY

GPO (General Purpose Outlet)

Where a power point is used it MUST be 230 V, rated at 10A and MUST be
earthed. This power point MUST NOT be located above the heater. Alternatively
the appliance can be direct wired if the power supply is to be concealed.
The heater engine is fitted with a 1.5 m power cord and three pin plug (7a) which
exits the appliance from the rear panel at the lower left.

Direct Wired Installations

Alternatively the appliance can be direct wired if so required.
A qualified electrician will need to be consulted where a direct
wired installation is required.
Any such installation MUST comply with the requirements
IMPORTANT of AS/NZS 5601, AS/NZS 3000 and any other relevant local
regulations.
Rinnai 11
SUPPLY CONNECTIONS
7a
RDV 600_700ER IM