Burner Media Installation; Ceramic Log Set Installation - Rinnai RDV600ER Installation Manual

BURNER MEDIA INSTALLATION

CERAMIC LOG SET INSTALLATION

Carefully unpack and inspect each log for damage
one at a time, temporarily returning each of the logs to
the packaging for safe keeping until required. If ANY
damage is evident on the logs DO NOT continue with
installation and contact your supplier for advice.
For clarity the drawings are displayed
without showing the entire heater.
NOTE
Use extreme care when handling the
Ceramic Log Set components, they are
made from a very fragile high temperature
material and will damage if handled
roughly. Only remove the components
from their packaging as required using the
specific order as stated.
Step 1. Removing the Burner Box Glass
A set of instructions is attached to the
burner box glass that has pictures of the
suggested stone media placement, ensure
to retain this instruction for use with
NOTE
"CERAMIC STONE SET INSTALLATION"
on page 26.
While supporting the burner box glass panel in place
(A), unscrew and remove the four retaining screws (B).
Once unscrewed pull the burner box glass panel away
and place it and the retaining screws safely aside where
the glass and frame can not get damaged or the screws
become lost.
Step 2. Burner Inspection
Check to ensure that the ports of the burner are clean
NOTE
and clear of any particles and all packaging material.
Step 3. Ember Bed Installation
Remove the stone guard (C), by unscrewing the three
retaining screws, then gently lift the stone guard out,
taking care to avoid scratching any of the interior surfaces
or fittings.
Fill the perforated ember tray (D) evenly with the glass
ember granules (E), then take between 6 to 8 pieces of
the black burner granules (F) and spread these randomly
over the glass layer of the ember bed.
When satisfied with the placement of the ember bed
material, carefully re-fit the stone guard (C).
Step 4. REAR Log Installation
Identify the "REAR" log and then carefully remove it from
the protective packaging.
Locate the two slots in the base of the log and carefully
place these over the positioning pins (G) which are
located at the rear of the burner box, ensuring that the
detailed surface of the log is facing out to the front.
Rinnai
Artificial log set as supplied
in protective packaging
i ii
v
1
2
3
D
4
24
LOG RDV600 RDV700
iii
i REAR FRONT
ii FRONT REAR
iv
iii MIDDLE
iv RIGHT
v LEFT
B
A
E
D
C
REAR log
G
RDV 600_700ER IM
F