Valet Mode - Chrysler 300c Owner's Manual

20_LX_OM_ENA_GCC_t.book Page 296
296 MULTIMEDIA
Eco Mode can only be turned on while in the
AUTO drive mode.
The Paddle Shifters will be disabled while in Eco
mode.
Changing the Drive Mode will deactivate Eco.

Eco will be disabled when another Drive

Mode is selected or Eco button is pressed.

VALET MODE

Valet Mode Activation
To enter Valet Mode, press the Valet button on
the touchscreen and a pop-up screen will ask
you if you would like to enter Valet Mode. After
selecting "Yes", you will be asked to enter a
four-digit PIN code. The PIN code is not set, so
you are free to select any four-digit numeric
combination that will be easy to remember.
While in Valet Mode, the following vehicle
configurations are set and locked to prevent
unauthorized modification:
Engine limited to the lowest power output

state.
On automatic transmissions, transmission

up-shifts earlier than normal.
Traction, steering, and suspension are set to

their Street settings.
Steering wheel Paddle Shifters are disabled.

The Drive Modes interface is not available.

Pressing the SRT button on the touchscreen
will display the unlock keypad.
The ESC Off button is disabled.

The Launch Control button is disabled.

Valet Mode Deactivation PIN
The Valet Mode Deactivation key pad will then
prompt you for your four-digit PIN code. Enter
your PIN code, and press the GO button on the
touchscreen. Your vehicle will return to the
default state whenever exiting Valet Mode.
NOTE:
If your four-digit PIN is lost or forgotten, the
vehicle will exit Valet Mode after a battery
disconnect for approximately five minutes.
Reconnect the battery and cycle the ignition to
the ON/RUN position; the vehicle will be in Auto
Mode.