Chrysler 300c Owner's Manual page 196

20_LX_OM_ENA_GCC_t.book Page 194
194 IN CASE OF EMERGENCY
Front Turn Signal Lamps
1. Open the hood.
NOTE:
Removal of the air cleaner filter housing may be
necessary prior to replacing bulbs in the head-
lamp assembly on the driver side of the vehicle.
2. Reach behind the headlamp housing to
access the turn signal (inboard) bulb cap.
Turn Signal Bulb Cap
3. Firmly grasp the cap and rotate it counter-
clockwise to unlock it.
Turn Signal Bulb Location
4. Squeeze the two tabs on the side of the bulb
socket and pull straight out from the lamp
assembly.
5. Disconnect the bulb from the wiring
connector and install the replacement bulb.
6. Install the bulb and connector assembly
straight into the lamp until it locks in place.
7. Install the turn signal bulb cap in the head-
lamp housing and rotate clockwise to lock in
place.
Front Fog Lamp
The Front Fog Lamps use LED sources that are
not serviceable separately. The Front Fog Lamp
must be replaced as an assembly; see an
authorized dealer.
Front/Rear Side Marker Lamp
The Side Markers use LED lamps that are not
serviceable separately. The Side Markers must
be replaced as an assembly, see an authorized
dealer.
Rear Backup Lamp And Turn Signal Lamps
The Rear Backup and Turn Signal Lamp use
LED sources that are not serviceable sepa-
rately. The Rear Lamps must be replaced as an
assembly, see an authorized dealer for further
information.
License Lamp
The License Lamp uses an LED source that is
not serviceable separately. The License Lamp
must be replaced as an assembly; see an
authorized dealer.