All Wheel Drive (Awd) - If Equipped; Rear Axle; Raising The Vehicle; Tires - Chrysler 300c Owner's Manual

Hide thumbs Also See for 300c:
Table of Contents

Advertisement

20_LX_OM_ENA_GCC_t.book Page 234
234
SERVICING AND MAINTENANCE
CAUTION!
Do not use chemical flushes in your
transmission as the chemicals can damage
your transmission components. Such damage
is not covered by the New Vehicle Limited
Warranty.
Fluid Level Check
The fluid level is preset at the factory and does
not require adjustment under normal operating
conditions. Routine fluid level checks are not
required; therefore the transmission has no
dipstick. An authorized dealer can check your
transmission fluid level using special service
tools. If you notice fluid leakage or transmission
malfunction, visit an authorized dealer immedi-
ately to have the transmission fluid level
checked. Operating the vehicle with an
improper fluid level can cause severe transmis-
sion damage.
CAUTION!
If a transmission fluid leak occurs, visit an
authorized dealer immediately. Severe
transmission damage may occur. An
authorized dealer has the proper tools to
adjust the fluid level accurately.
Fluid And Filter Changes
Under normal operating conditions, the fluid
installed at the factory will provide satisfactory
lubrication for the life of the vehicle.
Routine fluid and filter changes are not
required. However, change the fluid and filter if
the fluid becomes contaminated (with water,
etc.), or if the transmission is disassembled for
any reason.
All Wheel Drive (AWD) — If Equipped
The All Wheel Drive system consists of a
transfer case and front differential. The exterior
surface of these components should be
inspected for evidence of fluid leaks. Confirmed
leaks should be repaired as soon as possible.
The transfer case fluid fill/inspection plug is
located in the middle of the rear housing. To
inspect the transfer case fluid level, remove the
fill/inspection plug. The fluid level should be
even with the bottom of the hole. Use this plug
to add fluid as required.
The front differential fill plug is located on the
outer cover near the halfshaft attachment. To
inspect the differential fluid level, remove the fill
plug. The fluid level should be even with or
slightly below the bottom of the hole.
Fluid Changes
Refer to the "Service And Warranty Handbook
(Auto Biography)" for the proper maintenance
intervals.

Rear Axle

For normal service, periodic fluid level checks
are not required. When the vehicle is serviced
for other reasons the exterior surfaces of the
axle assembly should be inspected. If gear oil
leakage is suspected inspect the fluid level.
Refer to "Fluids And Lubricants" in "Technical
Specifications" for further information.

RAISING THE VEHICLE

In the case where it is necessary to raise the
vehicle, go to an authorized dealer or service
station.

TIRES

Tire Safety Information

Tire safety information will cover aspects of the
following information: Tire Pressures and Tire
Loading.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents