Chrysler 300c Owner's Manual page 137

20_LX_OM_ENA_GCC_t.book Page 135
Installing Child Restraints Using The Top Tether
Anchorage:
WARNING!
Do not attach a tether strap for a rear-facing
car seat to any location in front of the car
seat, including the seat frame or a tether
anchorage. Only attach the tether strap of a
rear-facing car seat to the tether anchorage
that is approved for that seating position,
located behind the top of the vehicle seat.
See the section "Lower Anchors and Tethers
for CHildren (LATCH) Restraint System" for the
location of approved tether anchorages in
your vehicle.
1. Look behind the seating position where you
plan to install the child restraint to find the
tether anchorage. You may need to move
the seat forward to provide better access to
the tether anchorage. If there is no top
tether anchorage for that seating position,
move the child restraint to another position
in the vehicle if one is available. Refer to
"Locating The Upper Tether Anchorages" in
this section for details on the location of the
tether anchorages.
2. Rotate or lift the cover to access the anchor
directly behind the seat where you are
placing the child restraint.
3. Route the tether strap to provide the most
direct path for the strap between the anchor
and the child seat. If your vehicle is
equipped with adjustable rear head
restraints, raise the head restraint, and
where possible, route the tether strap under
the head restraint and between the two
posts. If not possible, lower the head
restraint and pass the tether strap around
the outboard side of the head restraint.
SAFETY
Tether Strap Mounting
2 — Cover
3 — Attaching Strap
A — Tether Strap Hook
B — Tether Anchor
4. Attach the tether strap hook of the child
restraint to the top tether anchorage as
shown in the diagram.
5. Remove slack in the tether strap according
to the child restraint manufacturer's
instructions.
135
4