Chrysler 300c Owner's Manual page 14

20_LX_OM_ENA_GCC_t.book Page 12
12 GETTING TO KNOW YOUR VEHICLE
1st Press Of Key Fob Unlocks
This feature lets you program the system to
unlock either the driver's door or all doors on
the first push of the unlock button on the key
fob.
To change the current setting, refer to
"Uconnect Settings" in "Multimedia" for further
information.
Flash Lights With Lock
This feature will cause the turn signal lights to
flash when the doors are locked with the key
fob. This feature can be turned on or turned off.
To change the current setting, refer to
"Uconnect Settings" in "Multimedia" for further
information.
Headlight Illumination On Approach
This feature activates the headlights for up to
90 seconds when the doors are unlocked with
the key fob. The time for this feature is program-
mable, on vehicles equipped, through Uconnect
Settings. To change the current setting, refer to
"Uconnect Settings" in "Multimedia" for further
information.
To Unlatch The Trunk
Push the trunk button on the key fob two times
within five seconds to unlatch the trunk.
If the vehicle is equipped with Passive Entry,
refer to "Keyless Enter-N-Go — Passive Entry" in
"Doors" in this chapter for further information.
To Lock The Doors And Trunk
Push and release the lock button on the key fob
to lock all doors.
The turn signal lights will flash and the horn will
chirp to acknowledge the signal if programmed.
Refer to "Uconnect Settings" in "Multimedia"
for further programmable information.
NOTE:
To lock the doors with passive entry, Refer to
"Keyless Enter-N-Go — Passive Entry" in "Doors"
in this chapter for further information.
If one or more doors are open, or the trunk is
open, the doors will lock. The doors will unlock
automatically if the key fob is left inside the
passenger compartment, otherwise the doors
will stay locked.
Sound Horn With Lock
This feature will cause the horn to chirp when
the doors are locked with the key fob. This
feature can be turned on or turned off. To
change the current setting, refer to "Uconnect
Settings" in "Multimedia" for further informa-
tion.
Key Fob Battery Replacement
The recommended replacement battery is one
CR2032 battery.
NOTE:
Perchlorate Material — special handling may

apply.
Do not touch the battery terminals that are

on the back housing or the printed circuit
board.