Configuring Your System Using Ssu - Nortel CallPilot 702t Installation And Configuration Manual

October 2002

Configuring your system using SSU

Introduction
To run the SSU, restart your system using the Nortel Networks 702t
Meridian Application Server System Setup Utility disks (Version 3.0). There
are three disks.
To configure the system using SSU
1 Reboot the CallPilot server from the SSU Version 3 floppy disk.
2 Insert the floppy disks as requested.
3 The system detects the mouse and keyboard, and then boots into the
SSU banner window. Confirm that this is Version 3.x or greater.
Note: The following descriptions assume that you have a mouse
attached. If not, you can use the Tab or arrow keys to maneuver around
the SSU windows.
Part 5: 702t Server Maintenance and Diagnostics
SSU and BIOS
277