Nortel CallPilot 702t Installation And Configuration Manual page 252

Replacing or adding voice processing boards
To install an additional MPB16-4 board
.
To install an additional MPB16-4 board in a server that already has at least
one MPB16-4 board, follow these steps:
1 Unpack the new MPB16-4 board.
2 Install any MPC-8 cards that have been ordered for the new MPB16-4
board.
3 Identify the slot where the new MPB16-4 board will be installed. For slot
assignment information, see "Slot assignments" on page 290.
4 Remove the slot cover where the new board will be installed.
Save the retaining screw. You will reuse it to secure the new board.
5 Press the new MPB16-4 board firmly into its slot.
Note: Ensure that you carefully slide the MPB16-4 board past the
protective foil strips, as they are easily damaged.
6 Secure the board using the retaining screw you removed earlier.
7 Connect the SCbus cable to the two MPB16-4 boards.
8 Replace the server cover.
Note: Be careful not to pinch any cabling when sliding the server cover
back on.
9 Replace the front bezel and lock it.
10 If necessary, reconfigure the DS30X cabling to support the new capacity.
Refer to Part 3 of the CallPilot Installation and Configuration binder for
details.
252
DANGER
Risk of electrical shock
Ensure the server is powered down and the AC power cords
are disconnected, as described in "Before you begin" on page
250.
Standard 1.0
CallPilot