Restarting Services - Nortel CallPilot 1001rp Installation And Configuration Manual

Using serial port diagnostic tools

Restarting services

Introduction
This section describes how to restart the services for COM 1 or COM 2 after
invoking the TSTSERIO local loopback tests.
Services to restart after COM 1 testing
Routing and Remote Access Service
Services to restart after COM 2 testing
CallPilot SLEE Service
CallPilot MWI Service
CallPilot Access Protocol Emulator
CallPilot Blue Call Router
CallPilot Call Channel Router
CallPilot Time Service
Routing and Remote Access Service
Net Start command
Use the NET START command to restart a specified service on a serial port.
The syntax for the NET START command is as follows:
net start "[service-name]"
72
Standard 1.0
CallPilot