Nortel CallPilot 1001rp Installation And Configuration Manual page 266

Replacing or adding voice processing boards
Before you begin
.
1 Courtesy stop all CallPilot channels.
2 Power down the server and all peripheral devices.
3 Disconnect the power cables from the server and from all peripheral
devices.
4 Remove the server cover.
For instructions on removing the server cover, see "Removing the front
bezel and server cover" on page 128.
266
CAUTION
Risk of electrical damage
Wear an antistatic ESD wrist strap when handling cards or
boards, or when working inside the server.
Do not touch the components or gold-edge connectors of cards
or boards.
Place the card or board on an antistatic surface until you are
ready to install it.
Standard 1.0
CallPilot