Omron E8F2 Manual page 8

E8F2
J MODES
In addition to displaying measurement values, the E8F2 has a variety of functions. These functions are available in four main modes as
described below: Measurement Mode, Basic Setting Mode, Pressure Setting Mode, Special Setting Mode. Three functions are available
in measurement mode. For the relationships among each mode and for switching methods, refer to the following figure.
Zero-reset function
ON- and OFF-point
check function
or
Basic Setting Mode
unt: Measurement unit selection
m-a: Pressure setting method
selection
ope: Output-type selection
Note: 1. and indicate that the key must be pressed for approximately 2 or 3 s respectively.
2. The following will result when the E8F2 in basic, pressure setting, or special setting mode is reset to measurement mode.
: The set values are entered.
: The set values are not entered (left as they are).
*1.Manual setting is available by selecting m (manual) in the pressure setting method selection in basic setting mode.
*2.Auto-teaching setting is available by selecting a (auto-teaching) in the pressure setting method selection in basic setting mode.
Power ON
No key operation
or
Measurement
No key operation
Pressure Setting Mode
Manual setting
on: OUT1 ON-point setting
off: OUT1 OFF-point setting
on: OUT2 ON-point setting
off: OUT2 OFF-point setting
Mode
or
Auto-teaching setting
t.h1: OUT1 two-point teaching
t.w: OUT1 one-point teaching
t.h1: OUT2 two-point teaching
t.w: OUT2 one-point teaching
9
E8F2
Energy-saving function 1
Energy-saving function 2
or
Special Setting Mode
prt: Key-protect setting
hys: Hysteresis width setting
wid: Window width setting
dsp: Measurement value display
refresh interval setting
: Number of measurement times
aUe
setting for measurement value averaging
bar: LED bar indicator range setting