Omron E8F2 Manual page 16

E8F2
Hysteresis Width Setting
The hysteresis width can be changed by taking the following steps.
OUT1 OUT2 kPa Torr Psi
1. Press the SET key while hys is displayed to display the hysteresis width of OUT1 presently set.
2. Press the Up or Down key to change the set value within a range between 0 and 10.0% FS.
3. Press the SET key to select the displayed set value and display the hysteresis width of OUT2 presently set.
4. Press the Up or Down key to change the set value.
5. Press the SET key to select the displayed set value and display hys again.
6. Press the Up and Down keys simultaneously to display hys again without selecting the value.
Note: 1. Hysteresis Mode: No manual hysteresis width settings are enabled in hysteresis mode except for those set by auto-teaching.
Window Mode
Hysteresis width settings are enabled when the E8F2 in window mode is set to measurement mode.
2. ON- and OFF-point widths in hysteresis mode are used as hysteresis widths, which cannot be changed in window mode.
Window Range Setting
OUT1 OUT2 kPa Torr Psi
1. Press the SET key while wid is displayed to display the window width of OUT1 presently set.
2. Press the Up or Down key to change the set value within a range between 0 and 30% FS of the reference value.
3. Press the SET key to select the displayed set value and display the window width of OUT2 presently set.
4. Press the Up or Down key to change the set value.
5. Press the SET key to select the displayed set value and display wid again.
6. Press the Up and Down keys simultaneously to display wid again without selecting the set value.
Note: No window width settings will be enabled in hysteresis mode.
or
OUT1 OUT2 kPa Torr Psi
OUT1 OUT2 kPa Torr Psi
Press the Up or
Down Key to
change the set
value.
or
OUT1
OUT1 OUT2 kPa Torr Psi
Press Up or Down key
to change set value.
Hysteresis mode
ON
OFF
Window mode
ON
OFF
OUT2
ON
OFF
OUT1 OUT2 kPa Torr Psi
17
E8F2
Change in
hysteresis width
desired
Pressure
OFF
ON
value
point
point
Change in
hysteresis width
desired
Pressure
ON
value
OFF
point
point
(0 to 30%)
Pressure
Reference value
value
(TEACH1)