Photomicrosensor (Transmissive) EE-SX1107 ■ Dimensions Note: All units are in millimeters unless otherwise indicated. Optical axis Cross section AA Recommended Soldering Pattern Internal Circuit Terminal No. Name Anode Unless otherwise specified, the Cathode tolerances are ±0.15 mm. Collector Emitter ■ Electrical and Optical Characteristics (Ta = 25° C) Item Emitter Forward voltage...
Page 2
■ Engineering Data Forward Current vs. Collector Dissipation Temperature Rating Ambient temperature Ta (°C) Light Current vs. Collector−Emitter Voltage Characteristics (Typical) Ta = 25°C = 10 mA = 5 mA Collector−Emitter voltage V Response Time vs. Load Resistance Characteristics (Typical) = 5 V Ta = 25°C Load resistance R...
Page 3
Unit: mm (inch) ■ Tape and Reel Reel Tape Tape configuration Terminating part (40 mm min.) Tape quantity 2,500 pcs./reel 21±0.8 dia. 2±0.5 13± 0.5 dia. Product name Quantity Lot number Parts mounted Empty (40 mm min.) Pull-out direction Photomicrosensor (Transmissive) 330±2 dia.
Precautions ■ Soldering Information Reflow soldering • The following soldering paste is recommended: Melting temperature: 216 to 220° C Composition: Sn 3.5 Ag 0.75 Cu • The recommended thickness of the metal mask for screen printing is between 0.2 and 0.25 mm. •...
Page 5
III. PRECAUTIONS 1. Suitability: IT IS THE BUYER’S SOLE RESPOINSIBILITY TO ENSURE THAT ANY OMRON PRODUCT IS FIT AND SUFFICIENT FOR USE IN A MOTORIZED VEHICLE APPLICATION. BUYER SHALL BE SOLELY RESPONSIBLE FOR DETERMINING APPROPRIATENESS OF THE PARTICULAR PRODUCT WITH RESPECT TO THE BUYER’S APPLICATION INCLUDING (A) ELECTRICAL OR ELECTRONIC...
THE OMRON PRODUCT IS PROPERLY RATED AND INSTALLED FOR THE INTENDED USE WITHIN THE OVERALL EQUIPMENT OR SYSTEM. Complete “Terms and Conditions of Sale” for product purchase and use are on Omron’s website at http://www.components.omron.com – under the “About Us” tab, in the Legal Matters section.