Cisco Fm Ponte Kit Status And Link Leds; Unit And Link Quality Status - Cisco FM PONTE-50 Installation And Configuration Manual

Figure 3. Shielded CAT5/6 connector
Use only professional-quality, outdoor-rated, RF-shielded cables in
conjunction with Fluidmesh radio transceivers.
Assemble all shielded CAT5/6 connectors to the following standards:
• Only use shielded RJ45 Ethernet connectors.
• When inserting each connector into a shielded Ethernet port, the
connector's inner jacket must form a positive contact with the
Ethernet port.
• When each RJ45 connector is plugged into the correct Ethernet
port of the Cisco FM Ponte kit, lock the bottom of the RJ45
connector using the side retaining screws.
• When all RJ45 connectors are connected to the unit, make sure
that the bottom cover of the unit is correctly secured to the unit
enclosure.

5.1.3. Cisco FM Ponte kit Status and link LEDs

Unit and link quality status

The front panel of the Cisco FM Ponte kit (as seen below) contains seven
LEDs. The panel is used to check the unit status and wireless link quality
status.
Figure 4. Status and link/boot LEDs
During normal operation, the seven LEDs indicate the following
conditions:
• Power: The Cisco FM Ponte kit is receiving power.
• LAN1: Network activity on Ethernet port 1.
• LAN2: Network activity on Ethernet port 2.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
Page 20 of 132