Resetting The Unit; Understanding Cisco Aironet 600 Series Officeextend Access Point Leds; Accessing The Cisco Aironet 600 Series Officeextend Access Point Gui - Cisco CISCO673-RF - 673 Router User Manual

Chapter 1 Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Cisco Aironet 600 Series OfficeExtend access points are designed to work behind a router or other
Note
gateway device that is using network address translation (NAT). NAT allows a device, such as a home
router or gateway, to act as an agent between the Internet (public) and a personal network (private),
thereby enabling an entire group of computers to be represented by a single IP address. Only one Cisco
Aironet 600 Series OfficeExtend access point can be deployed behind a single NAT device.

Resetting the unit

To reset a 600 Series OfficeExtend AP, while the unit is powered on, hold the reset button dowon for 5
seconds to restart the unit. Then hold the reset button down for 20 seconds to clear the configuration and
restart the unit with the factory default settings.
Understanding Cisco Aironet 600 Series OfficeExtend Access
Point LEDs
The LEDs on the top panel indicate the operating status of the unit.
indications for 600 Series OfficeExtend Access Points. A properly functioning and configured AP
transitions from blinking blue to solid within ten minutes. Usually the time will be much shorter.
Table 1
Status LED
Purple
Blue
Flashing blue
Flashing orange
Cycling through purple, orange, and
blue
Cycling through purple, orange
Orange
Accessing the Cisco Aironet 600 Series OfficeExtend Access
Point GUI
Follow these steps to access the Cisco Aironet 600 Series OfficeExtend access point GUI.
Step 1 Connect your laptop to the local Ethernet port 1, 2, or 3 on the 600 Series OfficeExtend access point.
LED Status Indications for 600 Series OfficeExtend Access Points
Meaning
Association status, when CAPWAP is connected: Normal
operating condition, but no wireless client associated.
Association status, when CAPWAP is connected: Normal
operating condition, at least one wireless client association.
Operating Status: Software upgrade in progress.
Operating Status: No IP address, waiting for DHCP IP.
Operating Status: Discovery/join process in progress, no
client associated.
Operating Status: Discovery/join process in progress, with
client associated.
Cisco IOS errors: Software failure; try disconnecting and
reconnecting unit power.
Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Resetting the unit
Table 1 provides LED status
1-5