Changing The Operational Mode; Operational Mode Settings On A Bridge Network-Only Unit - Cisco FM PONTE-50 Installation And Configuration Manual

• Click the -general mode link under GENERAL SETTINGS in the
left-hand settings menu (below).
Figure 17. Configurator GUI (General Mode)
• The GENERAL MODE dialog will be shown
(page

Changing the operational mode

Operational mode settings on a bridge network-only unit

The Cisco FM Ponte kit kit contains two radio transceiver units. Both units
can only be operated in Bridge Mode.
The Fluidmesh device ID number of the unit that forms the opposite side
of the wireless bridge will be shown in the Configurator window heading
block (Figure 18 (page
Figure 18. Configurator window heading block
The Bridge ID of the remote unit to which the local unit must be linked is
set at the factory and does not need configuration.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
45)).
45)).
(Figure 17
Page 45 of 132