Reactivating A Deactivated Plug-In - Cisco FM PONTE-50 Installation And Configuration Manual

• The PLUG-IN DEACTIVATION dialog will be shown.
10. To do a normal deactivation, click the Deactivate button. If for
any reason it is not possible to retrieve the deactivation code,
click the Force Deactivation button.
• The plug-in will be deactivated.
• The Deactivation code will be shown in the Deactivation
Code column of the plug-in listing.
• The Deactivation code will remain on the Partner Portal,
and can be used to generate a new Activation code if
needed.

8.2.3. Reactivating a deactivated plug-in

To use a Deactivation code to generate an new Activation code, do the
following steps:
1. Log on to the
2. Click the Plug-ins link.
• The Plug-ins web page will be shown
109)).
Figure 53. Partner Portal (Plug-ins web page)
3. Check the selection check-box to the left of the relevant plug-in
listing.
© 2021 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
Only click the Force Deactivation button if you have
no way to retrieve the deactivation code (for
example, if the unit's boot sequence cannot be
completed, or if the unit is damaged and cannot be
powered ON).
Fluidmesh Partner Portal.
Software Plug-Ins
(Figure 53 (page
Page 109 of 132