Cisco FM PONTE-50 Installation And Configuration Manual page 55

IMPORTANT
If you are working within a Fluidity Layer-3 network cluster, and
the network cluster has more than one Mesh-end radio, access
FM-QUADRO through the Configurator interface of the
cluster's Primary Mesh-end.
Find the Primary Mesh-end by comparing the Mesh ID values
of the Mesh-end radios. The Primary Mesh-end will have a
numerically lower Mesh ID value than the Secondary Mesh-
end.
If you access the FM-QUADRO interface belonging to the
cluster's Secondary Mesh-end, the network topology view will
be shown, but some statistics and configuration information
may not be available for viewing.
• A graphical view of the current network topology will be shown. A
typical example is shown below.
• Stationary (wayside, or infrastructure) Fluidmesh radio transceivers
are shown as colored icons (below).
• Stationary radio transceiver icons are colored according to the
performance of their data links relative to preset KPI thresholds:
• If an icon is red, the performance of at least one link is below
standard (red link line).
• If an icon is orange, the performance of at least one link is
acceptable, but not optimal (orange link line).
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Page 55 of 132