Cisco FM PONTE-50 Installation And Configuration Manual page 30

5. Remove the hexagon nut and rubber seal from
the cable gland.
IMPORTANT
The use of pre-made Ethernet
cables is recommended. The
rubber seal is pre-cut, allowing
pre-made Ethernet cables to be
used.
6. Make sure that the cable gland is securely
screwed into the bottom housing.
9. Correctly align the bottom housing with the
main body of the unit. Press the bottom housing
into the main body.
10. Tighten the two screws that secure the
bottom housing to the main housing.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
7. Route the LAN cables through the hexagon
nut, the rubber seal, and the cable gland on the
bottom housing.
CAUTION
If you are running only one
Ethernet cable through the
rubber seal, block the second
cable hole with a one-inch
cable stub only.
8. Connect the RJ45 connectors to the correct
LAN ports as shown in "Connecting LAN cables
to the unit" (page 29).
11. Slide the rubber seal toward the unit until it
seats inside the cable gland.
12. Tighten the hexagon nut.
Page 30 of 132