Miscellaneous Settings - Cisco FM PONTE-50 Installation And Configuration Manual

Parameter
Tagged with null VID (0) or NVID
Access port rules for incoming packets with unit in Bridge Mode (Case and
Action)
The Native VLAN enable setting is used to control whether the Management VLAN
should be tagged or not.
Untagged packet, to remote devices
Tagged packet (any VID), to remote
devices
Untagged packet, to local unit kernel
Tagged packet (any VID), to local unit
kernel
Access port rules for outgoing packets with unit in Bridge Mode (Case and
Action)
Tagged packet with valid VID from
remote peer
Tagged packet with null (0) VID from
remote peer
Packet from local unit kernel

7.6.7. Miscellaneous settings

The MISC SETTINGS window contains controls to change the following
settings:
• The device name, as used to identify the Cisco FM Ponte kit within
the FMQuadro network map and to other Fluidmesh utilities.
• The operation of the physical Reset button on the unit.
To change any of the miscellaneous settings, do the following steps:
1. Click the -misc settings link under ADVANCED SETTINGS in
the left-hand settings menu.
• The MISC SETTINGS dialog will be shown
(page
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Packet passed (untagged)
Pass packet to remote peer
Pass packet to remote peer with original
tag
If native VLAN = ON: Packet passed to
kernel, tagged with NVID
If native VLAN = OFF: Packet not
passed to kernel
If native VLAN = ON: Packet not
passed to kernel
If native VLAN = OFF: Packet passed to
kernel if VID = NVID
Packet passed (tagged)
Packet passed (untagged)
If native VLAN not equal to MVID:
Packet passed, tagged with MVID
If native VLAN = MVID: Packet passed,
untagged
81)).
Default value
(Figure 34
Page 80 of 132