Connecting Lan Cables To The Unit; Bottom Housing And Rj45 Lan Cabling - Cisco FM PONTE-50 Installation And Configuration Manual

5.2.2. Connecting LAN cables to the unit

Bottom housing and RJ45 LAN cabling

CAUTION
When loosening the screws that secure the bottom housing to
the main body of the unit, do not remove the screws.
Removing the screws will damage the main body.
When the Cisco FM Ponte kit is mounted in its final location, connect the
unit to LAN connection(s) and a PoE power supply by doing the following
steps:
1. Only use shielded CAT5/6 cables that terminate in RJ45 Ethernet
connectors at both ends.
2. Make sure that the terminal pin assignments for the RJ45 plugs
comply with the accepted standard for RJ45 LAN/PoE
connectors.
Next, proceed to the steps in the following table:
3. Loosen the two screws that secure the bottom
housing to the main housing. The location of one
of the screws is shown above. The second screw
is on the opposing side of the unit.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
4. Separate the bottom housing from the main
body of the unit.
Page 29 of 132