Cisco FM PONTE-50 Installation And Configuration Manual page 78

IMPORTANT
For detailed information on the predefined rules for packet
management, refer to the
(page 79)
To connect the unit to a VLAN that is part of the local wireless network, do
the following steps:
1. Click the -vlan settings link under ADVANCED SETTINGS in the
left-hand settings menu.
• The VLAN SETTINGS dialog will be shown
(page
Figure 33. Configurator GUI (VLAN SETTINGS dialog)
2. Connect the unit to a VLAN that is part of the local wireless
network by checking the ENABLE VLANs: check-box.
3. Enter the management identification number of the VLAN (used
to communicate with the device's operating system) in the
Management VLAN ID: field.
4. Enter the native identification number (the VLAN ID implicitly
assigned to untagged packets received on trunk ports) in the
Native VLAN ID: field.
5. Save the VLAN settings by clicking the Save button. Alternatively,
clear the settings by clicking the Reset button.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
"Rules for packet management"
table at the bottom of this section.
78)).
NOTE
The same Management VLAN ID number must be
used on all Cisco FM Ponte kit devices that are part
of the same bridge network.
(Figure 33
Page 78 of 132