Table of Contents
Advertisement
Digital
2.2.1 Transimitter antenna
For best signal quality, make sure that the antenna is at about a 90 degree
angle Warning to the model. Do not point the antenna directly at the receiver.
Never grip the transmitter antenna during operation. It significantly
degrades Danger the RF signal quality and strength and may cause loss of control.
2.2.2 Battery indicator
The status indicator is used to indicate the power and status of the transmitter and receiver. If a receiver
is not connected or bound to the transmitter no battery status will be displayed for the receiver.
TX
2.2.3 Trims
Th ere are 4 trims affecting stick functionality, one for ailerons (Channel 1), elevator (Channel 2) throttle
(Channel 3) and rudder (Cha n n e14) Each time a trim is toggled, the trim will move one step. It is
possible to make quicker trim adjustments by holding the trim in the desired direction. When the trim
position reaches the middle, the transmitter beeps in a higher tone.
2.3 Receiver overview
Antenna
2.3. Reviever antenna
Attention For best signal quality, ensure that the receiver is mounted away from motors or
metal parts.
2.3.2 Connectors
The connectors are used to connect the parts of model and the receiver.
CHI to CH6: used to connect the servos, power or other parts.
B/VCC: used to connect the bind cable for binding, and the power cable during normal operation.
3.Getting Started
Before flight check the following guidlines to set up your system.
Proportional
RX
park fly
•
CHANNELS
R EC EIVER
24 GHZ 6
Radio
Control
0-6 5V/DC
o a o
CH5
CH4
CH3
r.H2
CHI
FS-i6
System
B/VCC
To servo
- Quick Links:
- Flight Control
- Model Select
Hide quick links:
Advertisement
Table of Contents
