Operation Instructions; Power On; Binding; Pre-Use Check - Fly Sky FS-i6 Instruction Manual

Digital

4. operation instructions

After setting up, follow the instructions below to operate the system.

4.1 Power on

Follow the steps below to turn on the system:
1. Check the system and make sure that:
The batteries are fully charged and installed properly. The
receiver is off and correctly installed.
2. Hold the "POWER" switche until screen lights up.
3. Connect the receiver power supply to the B/VCC port on the receiver.
Note: The system is now powerd on. Operate with caution, or serious injury could result.

4.2 Binding

The transmitter and receiver have been pre-bound before delivery. If you are using another transmitter
or receiver, follow the steps below to bind the transmitter and receiver:
1. Connect the supplied bind cable to the B/VCC port on the receiver.
2. Insert power into any other port.
3. Hold the "BIND KEY" while powering on the transmitter to enter bind mode.
4. Remove the power and bind cable from the receiver. Then connect the power cable to the B/VCC
port.
5. Check the servos' operation. If anything does not work as expected, restart this procedure from the
beginning.

4.3 Pre-use check

Before operation, perform the following steps to check the system:
1. Check to make sure that all servos and motors are working as expected.
2. Check operating distance: one operator holds the transmitter, and another one moves the model
away from the tra nsm itter. Check the model and mark the distance from where the model starts
to lose control.

4.4 Power off

Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Hold the transmitter's power buttons to turn off the transmitter.
10
Radio
Proportional
System
Control
FS-i6