Reverse; End Points - Fly Sky FS-i6 Instruction Manual

5.

5.2 Reverse

The reverse function changes a channels direction of movement
in relation to its input. For example, if a servo has to be mounted
upside down due to space restrictions within a model, this
function can be used to correct its movement so that it matches
up with the user controls.
Setup:
1. To change between normal and press the "OK" key until the
desired channel is selected, then use the "UP" and "DOWN"
keys to change setting.
bule being high.
To change an endpoint:
1. Press the "OK" to change channels.
2. Move the channel using its stick or knob to select the low
or high side.
3. Use the "UP" and "DOWN" keys to increase or decrease the
value.
Nor = Normal, Rev = Reverse.
2. Hold the "CANCEL" key to save and return to the previous
menu.
The end points function changes the range of movement available to a channel. This can be used to
prevent damage to a model when a servo moves too fa r, potentially leading to damage to pushrods
etc. The left box is the low end point, the right box is the high end point, marked below as low being
red and
4. Hold the "CANCEL" key to save and return to the previous menu.
3. To
Throttle Up

5.3 End points

Throttle Down
Ch 1 2 3 4 S 6
return to default
settings press and hold the
"OK" key for
seconds.Press and hold
the"CANCEL"key to save.
Reverse
End po
ints
Chi*
Ch2
Ch3 100"
Ch4 100% 100%
ChS 100% 100%
Ch6 100% 100%
3