Choose Sensors; Speed-Distance - Fly Sky FS-i6 Instruction Manual

Digital
are listed in the failsafe menu. [Off] means that in case of a loss of signal, the corresponding servo will
keep its last received position. If it displays a percentage, the servo will instead move to the selected
position.
Setup
1.
Use the "UP" and "DOWN" to choose a channel and press
"OK" to enter its failsafe settings.
2.
Use the "UP" and "DOWN" to turn the failsafe on or off.
3.
Move the channels control surface to the desired position
and hold the "CANCEL" key to confirm and exit.
4.
Press and hold the "CANCEL" key again to save all changes
in this function and return to the RX setup menu.
8.5 Sensors list
Fai IsaFe
This function is used to display information from the current active sensors.
[Type]:The type of sensor is displayed on the left hand side under [Type]
The first sensor in the list is the TX internal voltage and error rate. The second sensor is the first external
sensor is the receivers voltage sensor, this continues up to 15 sensors, if connected.
ID of each sensor is in the middle under [ID],
At the bottom of the list this menu has an error rate display, which is a good indicator of signal quality.

8.6 Choose sensors

This function changes which sensors will be displayed on the home screen. The home screen can display
up to 3 sensors.
To add a sensor to the home screen:
1. Use the "OK" key to change sensor slot
2. Use the up and down keys to select a sensor.
3. Press and hold the "CANCEL" key to save and exit.

8.7 Speed-distance

This function is used to detect the speed and distance traveled by the model.
[Speed sensor] Used to select the speed sensor if connected.
[Rotation length] If the sensor is mounted on a rotating part the distance from the centre point to the
sensor must be input in order to calculate the correct speed.
[Reset Odometer 1] Resets odometer 1. Odometer 1 records total distance traveled from all sessions until
reset.
[Reset Odometer 2] Resets odometer 2. Odometer 2 records the distance traveled in the current session.
22
Radio
Proportional
sensor' s output is on the right under [Value].
System
Control
All
1 OFF
Channel
2 OFF
Channel
*Channel 3 -100%
4 OFF
Channel
Channel S OFF
Channel 6 OFF
a 1 1 channe
Is
FS-i6
channels
numerical