I-Bus Setup; Servos Ferq - Fly Sky FS-i6 Instruction Manual

8.8 i-BUS setup

This function is used to set up the i-BUS module. The i-BUS module can be used to add servos to
your model tha may be too far away from the receiver. Setup:
1.
Use the "UP" and "DOWN" keys to choose a channel and press "OK".
2.
Press the button on the i-bus module that corresponds to the desired output.
3.
After setting up the desired channels press and hold the "CANCEL" key to save and exit.
8.9 Servos freq
This function sets the frequency that the receiver outputs to the servos. Check your servos usermanual
to find the correct setting.