Rx Setup; Rf Standard; Ppm Output; Rx Battery - Fly Sky FS-i6 Instruction Manual

Digital

8.1 RF standard

This menu allows you to change the communication protocol for the transmitter. The available protocols
a re:
RF Protocol
AFHDS
AFHDS 2A
To Switching Between AFHDS 2A and AFHDS:
1. First navigate to the system menu by pressing and holding the "OK" key until the main menu opens,
select "System Setup" by pressing the "OK" key again.
2. Use the "DOWN" key to navigate to "RX setup" and press the "OK" key again to enter, then press the
"OK" key one more time to select RF Standard.
Press the "UP" or "DOWN" button to select the latest protocol,AFHDS 2A 2-Way (The most advanced
and stable protocol) After restarting the system the new protocol will become the default.
3. Use the "UP" and "DOWN" keys to select a mode then press and hold the "CANCEL" key to save and
exit.

8.2 PPM output

PPM is capable of transferring all channels through one physical output. When [RX PPM output] is
checked, the receiver outputs PPM on CHI output and the other outputs are disabled.
When [PWM] is selected the receiver will output channels 1-6 via channel 1-6.
When [PPM] is selected the receiver will output a standard PPM signal via the PPM interface.
To turn the function on press the "UP" or "DOWN" keys to turn the function on then press and hold the
"CANCEL" key to save and exit.

8.3 RX battery

This function is used to change the battery monitor settings. This function can be switch to an external or
internal sensor.
There are 4 settings:
[External sensor/ Internal Sensor] The system has its own voltage sensor however it is possible to change
to an external sensor.
[Low] Sets the low battery voltage, see your batteries user manual to set this setting.
[Alarm]Sets the voltage level at which the system will allert the user if the battery gets too low.
[High]Sets the voltage for the battery if it is full.
These settings affect how the system shows battery levels, if the high and low are incorrect the
systems battery display will not be reliable.
8.4 Failsafe
This function is used to protect the models and users if the receiver loses signal and therefore is no longer
controllable.
21
Radio
Proportional
A3, A6,X6, iA4B, iA6, iA6B, iA10, iAIOB
System
Control

8 RX Setup

Receiver
FS-i6