Student Mode; Sticks Mode; Lcd Brightness; Firmware Ver - Fly Sky FS-i6 Instruction Manual

Digital

7.7 Student mode

Student mode is used when another system is connected as a master (Trai ner) when this mode is active
all settings will be bypassed and the system will only function through the master.
Setup:
1. To enable the function press "OK" then select Yes, The system will return to the previous menu.
2. To exit student mode repeat this process.

7.8 Sticks mode

There are 4 available stick modes, each stick mode changes
functions. For example when using stick mode 2 the
throttle on the vertical axis and rudder in
however in stick mode 3, the vertical axis controls elevator and the
horizontal axis controls aileron. These Ch4Chi modes are largely down
to personal preference. Setup:
To change stick modes use the "UP" and "DOWN" keys to select
a stick mode, then press and hold the "CANCEL" key to save and
exit.
When switching between modes 1/3 and 2/4 it is nessesary to reverse the gimbals positions to ensure
that throttle is on the correct side.

7.9 LCD brightness

To change the LCD brightness use the "UP" and "DOWN" keys. Press and hold "CANCEL" to save and exit.

7.10 Firmware ver.

This function displays the current firmware version.
7.11 Firmware update
This function updates the firmware using a USB to PS/2 connection lead.
Setup:
1. First download the update from our website,http://www.flysky-cn.com.
2. Connect the system to the computer via the supplied cable and press "OK" while in this function.
3. Wait for windows to recognise the system.
4. Then open the update on the computer and press "Start Upgrade".
5. Once the update is finished cycle the system power.

7.12 Factory reset

This function resets the entire system back to its factory settings. To reset press ok, then use the up and
down keys to select yes and press ok again.
20
Radio
Proportional
Ch3 the horizontal axis,
System
Control
St i cks mode the stick
Mode 2 left stick controls
FS-i6