Display; Aux. Channels; Subtrim - Fly Sky FS-i6 Instruction Manual

Digital

Display

This function displays the model's channel output in real time.
Setup:
1. Hold the "OK" key to enable channel scrub mode. In this
mode the channels will sweep though their entire range of
motion.
2. Press "CANCEL" key to exit.
Make sure the model engine is powered off
while the test function is activated.
Warning If powered on, it will rev up and cause unexpected
results.
Make sure the model does not go out
Danger
of range.

5.5 Aux. channels

The auxiliary channels function can be used to assign switches to extra channels to control additional part
of a model such as landing gear or lights.
In some model types, such as the variable pitch helicopter model, the 6th channel will already be in use.
In model types that use a gyro the fith channel will already be in use.
To assign a switch or know to an Aux channel:
1. Press the "OK" to change channels.
2. Use the "UP" and "DOWN" keys to select a source (Switch
or Knob/None)
3. Hold the "CANCEL" key to save and return to the previous
menu.

5.6 Subtrim

Subtrim changes the center point of the channel. For example, if a models rudder is slightly out of
alignment, the sub trim could be used to fix this.
To set the subtrim:
1. Press the "OK" to change channels.
2. Use the "UP" and "DOWN" keys to change the sub trim
Radio
Proportional
System
Control
D
1
i
sp
= aux . channe Is —
*Channel S
*Source Ura
Channe 1 6
Source UrB
Subtr i m
*Chi
Ch2 1.....................................±....................................1
FS-i6