Table of Contents
Advertisement
Blinds and switch actuator RMG 8, blinds actuator JMG 4
and switch actuator module RME 8 - EIB
5 Operation
5.1 Operating Controls
5.1.1 Buttons
The buttons are used to switch the relays on and off.
Via an ETS parameter on the General tab you can lock the keyboard to protect it against unauthorized
use.
If a channel is parameterised as a drive mechanism, the up and down relays are locked relative to each
other, i.e. they cannot be switched on at the same time.
5.1.2 Light Emitting Diodes
Functions:
•
Display of the relay statuses.
•
Flashing upon actuation when the keyboard is locked or a priority is active. (Also refer to the
appendices
"Priority Order of the Switching Output Controller / of the Drive Controller").
5.2 Manual Mode
The manual mode is selected by pressing the manual key on the device.
The conditions for exiting this mode can be parameterised (refer to Table 1-1: Parameters on the
"General" tab).
5.2.1 Manual Mode for Drive Channels
In this mode, the drives can be moved manually via the device.
All the bus telegrams not relevant for security aspects are locked, i.e.:
only the security instructions (sent to obj. 40...42) and the forced up/down commands will still be
executed.
5.2.2 Manual Mode for Switching Channels
In manual mode, the individual switching channels can only be switched on and off manually at the
device.
All the bus telegrams are inhibited, i.e. bus commands will not be executed.
As of: Apr-06 (Subject to change without notice)
theben
Page 30 of 36
Advertisement
Table of Contents
