Troubleshooting - Theben RMG 8 Manual

Blinds and switch actuator RMG 8, blinds actuator JMG 4
and switch actuator module RME 8 - EIB

6.4 Troubleshooting

Indicator / Error
Power LED flashes
Communication problems with the ETS
Manual mode LED flashes with the Key plugged
after actuating the manual button.
As of: Apr-06 (Subject to change without notice)
Possible cause / Remedy
Indicates that the Key has been plugged
An RME 8 or RMX 4 extension module was
parameterised but is either defective or not
available.
No EIB connection, no bus voltage
ETS application not loaded or device is being
programmed.
1. Disconnect the EIB from the actuator
2. Press the programming button and keep it
depressed
3. Connect the EIB again
4. As soon as the programming LED lights up,
the button can be released again
Remove the Key briefly.
theben
Page 35 of 36