Table of Contents
Advertisement
Blinds and switch actuator RMG 8, blinds actuator JMG 4
and switch actuator module RME 8 - EIB
4.4.3 Feedback of the Drive Mechanism Height and Slat Positions
In the ETS, the Height [%] object can additionally be parameterised as a feedback object that sends a
new position to the bus as a percentage.
The value sent refers to the parameterised total running time of the drive mechanism.
Procedure (ETS projection):
•
Highlight the object
•
Open the "Edit Object" window (double-click on the object)
•
Highlight the desired group address
•
click on the "Set sending" button and activate the "Transmit" checkbox
•
confirm your input
The same procedure can be used for the Slats [%] object.
Example:
Address 02/0/051 Control of the drive mechanism height for several drive mechanisms
Address 02/0/052 Feedback of the position of drive 4
IMPORTANT:
A feedback address must never be connected to another actuator input!
Annotation:
•
A noticeable deviation between the value sent and the nominal value is attributable to
conversion and rounding.
•
For height and position objects polling:
If a new value is transmitted to one of those objects during auto comfort or safety mode, the
old value will be cleared by the new one, but the drive will remain in its prior position.
In this case, the object value will not display the real drive position.
As of: Apr-06 (Subject to change without notice)
theben
Page 29 of 36
Advertisement
Table of Contents
