Table of Contents
Advertisement
Work plug 1 with the cable
through tail bottom section 2
until clear.
with alarm system (DWA)
Disconnect plug 1 for the anti-
theft alarm.
NOTICE
Before disconnecting the plug for
the anti-theft alarm, check that
DWA has been deactivated in the
SETUP MENU
.
Remove screw 4.
Remove anti-theft alarm 2, dis-
engaging it from bracket 3.
OE
Disengage plug 1 for the
number-plate carrier.
Remove body-bound rivet 2.
Remove bracket 3 for the anti-
theft alarm.
Remove screws 4 with wash-
ers 3.
Remove number-plate carrier 2
and work cable leg 1 out until
clear.
Install the rear seat (
Installing number-plate
carrier
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Removing rear seat (
5
87
61).
z
61).
Advertisement
Table of Contents
