Transmission damage
Do not allow the motorcycle to
roll for longer periods or push it
over longer distances with the
engine switched off.
Switch on ignition.
Pre-Ride Check in progress.
(
71)
ABS self-diagnosis is
performed. (
72)
with Automatic Stability Control
(ASC)
OE
ASC self-diagnosis is per-
formed. (
72)
Engage neutral, or pull back
clutch lever if a gear is en-
gaged.
NOTICE
You cannot start the motorcycle
with the side stand extended and
a gear engaged. The engine will
switch itself off if it is started with
the transmission in neutral and
then a gear is engaged before
retracting the side stand.
For cold starts and at low am-
bient temperatures: pull lever
to disengage clutch and twist
throttle grip slightly.
Press starter button 1.
NOTICE
The starting attempt is automati-
cally interrupted if battery voltage
is too low. Recharge the battery
before you attempt to start the
engine again, or use jumper ca-
bles and a donor battery to start.
More detailed information can
be found in the "Maintenance"
chapter under "Jump-starting".
Engine starts.
If the engine fails to start, the
troubleshooting table in the
chapter "Technical Data" may
provide assistance. (
Pre-Ride Check
When the ignition is switched on
the instrument cluster performs a
test routine including the analog
display instruments as well as the
warning and indicator lights - this
is the "Pre-Ride-Check." Starting
the engine before the test rou-
tine is completed will cancel the
remainder of the routine.
Phase 1
The needles on the tachometer
and speedometer rotate to their
end positions. Simultaneously all
warning and indicator lights are
activated sequentially.
7
71
140)
z