Table of Contents
Advertisement
Install a new battery while mak-
6
ing sure that positive terminal
of battery is at top.
66
Position lower housing section
on nose 5 of front edge and
close while watching two guide
pins 6.
Install screw.
The LED of the remote control
lights up; i.e. the remote con-
trol must be activated.
z
To activate the remote control
within the range of the receiver,
press the button 1 twice.
LED 2 begins to flash and
goes out after a few seconds.
The remote-control is again
ready to be used.
Advertisement
Table of Contents
